listen2
I'm not sure if there's a setting I'm just not seeing but when u hold the platter down on the ddj1000 and release there's a delayed start up when released. This does not occur in serato, so my guess is not the controller. Thanks in advance
发表时间 Sat 27 Feb 21 @ 5:03 pm
klausmogensen
Yes there is quite a few settings for that
Try typing in "jog" in the settings, and play with them to find your sweet spot between everything being over-sensitive, and everything feeling delayed
Try typing in "jog" in the settings, and play with them to find your sweet spot between everything being over-sensitive, and everything feeling delayed
发表时间 Sat 27 Feb 21 @ 6:21 pm
Rune (DJ-In-Norway)
touchwheelBackspin set to "no" in settings, can make it feel more responsive.
Since the software can "safely assume" you wont be dont that from a dead still jog
Since the software can "safely assume" you wont be dont that from a dead still jog
发表时间 Sat 27 Feb 21 @ 6:52 pm
PhantomDeejay
Your description doesn't help, but also check rampStartTime and rampStopTime.
Ideally you want these at 0.0
Also you can change the touchwheelSpinThreshold setting to make the deck resume normal playback speed in higher or lower platter speed after a release
Ideally you want these at 0.0
Also you can change the touchwheelSpinThreshold setting to make the deck resume normal playback speed in higher or lower platter speed after a release
发表时间 Sat 27 Feb 21 @ 9:24 pm
listen2
All good suggestions guys, thanks!
I'm just stopping the track playing with a finger on the platter. Then when I quickly lift my finger to release there's a noticeable lag. I see it the most when scratching slow and release.
L2
I'm just stopping the track playing with a finger on the platter. Then when I quickly lift my finger to release there's a noticeable lag. I see it the most when scratching slow and release.
L2
发表时间 Sun 28 Feb 21 @ 12:55 am
Rune (DJ-In-Norway)
listen2 wrote :
Then when I quickly lift my finger to release there's a noticeable lag. I see it the most when scratching slow and release.
But the suggestions above didnt "fix" that ?
发表时间 Sun 28 Feb 21 @ 12:25 pm
listen2
Yes, thank you guys. Backspin set to NO, seemed to resolve the issue, but it didn't make total sense so what I did was keep that enabled and tweak the the touch wheel spin threshold. That was set to 0 and by changing to 1 did the trick.
发表时间 Sun 28 Feb 21 @ 2:24 pm
PhantomDeejay
listen2 wrote :
That was set to 0 and by changing to 1 did the trick.
I wouldn't go as bold as 1.0, at least not without trying intermediate values first.
So I would suggest you to try values like 0.8/0.85/0.9 etc first before going to 1.0
发表时间 Sun 28 Feb 21 @ 10:40 pm
listen2
Will do, thanks you guys!
发表时间 Mon 01 Mar 21 @ 6:05 pm