Hardware Manuals


Reloop|瑞路普 - Terminal Mix 4 - Layout  

Effect Controls


This section offers control of 3 Effect slots per deck, Beatgrid adjustments, Master video Effects and Video Transition controls.

  1. FX1 ON. Press this button to enable/disable the selected effect of FX Slot 1. Hold SHIFT down and then press this button, to select the next available effect for FX Slot 1.

  2. FX1 knob. Controls the 1st parameter of the selected effect of FX Slot 1. Hold SHIFT down and use this knob to control the 2nd parameter of the selected effect of FX Slot 1.

  3. FX2 ON. Press this button to enable/disable the selected effect of FX Slot 2. Hold SHIFT down and then press this button, to select the next available effect for FX Slot 2.

  4. FX2 knob. Controls the 1st parameter of the selected effect of FX Slot 2. Hold SHIFT down and use this knob to control the 2nd parameter of the selected effect of FX Slot 2.

  5. FX3 ON. Press this button to enable/disable the selected effect of FX Slot 3. Hold SHIFT down and then press this button, to select the next available effect for FX Slot 3.

  6. FX3 knob. Controls the 1st parameter of the selected effect of FX Slot 3. Hold SHIFT down and use this knob to control the 2nd parameter of the selected effect of FX Slot 3.

  7. TAP. Press this button (for at least 4 times while track is playing) to manually tap the tempo of the track
    Hold SHIFT down and then press this button to set the TAP button and the BEATS ENC (19) to Video mode (led will be On)
    The Video mode is side/deck dependent (can be enabled/disabled on either side separately).

    In Video mode, use the button on the left side to trigger the selected Video Transition, and the button on the right side to trigger the selected Video Effect on Master.

  8. BEATS ENC. Use the encoder to move the track forward or backwards by 1 beat. Hold SHIFT down and then use this encoder to move the CBG of the track by 1 beat forward or backwards.

    If the Video mode is enabled, use the encoder on the left side to select a Video Transition and the encoder on the right side to select a Video Effect on Master. Hold SHIFT down and then use the same encoders to adjust the 1st parameter (if available) of the selected Video Transition or Video Effect on Master respectively
Loops