SHIFT (SECONDARY) ACTIONS SHIFTPress this button down to access secondary actions as described in the SHIFT ACTION column 1 PLAYPlay-pause loaded trackPlay-stutter loaded track2 CUESet a temporary Cue point at current position when track is paused or preview while pressed if Cue point is assigned. Return to this Cue point when track is playingJump to the beginning of the track3 JOGTouch-sensitive jogwheel for scratching (Vinyl mode enabled), pitch-bending (Vinyl mode disabled) of fine Loop In/Out adjustments. Vinyl mode can be enabled/disabled from VirtualDJ GUI Fast-searching through loaded track4 LOOP INWhen not in loop, set current position as the beginning of a Manual Loop. When in loop, jump to the beginning of the loop. Hold for more than 2 seconds to trigger a 4 beats auto-loop.Enable/disable Loop In Adjust mode. When this mode is enabled and track is in loop (led blinks), use the jogwheel to fine-adjust the Loop In point.5 LOOP OUTWhen not in loop, set current position as the end of a Manual Loop and trigger the loop. When in loop, exits the loopEnable/disable Loop Out Adjust mode. When this mode is enabled and track is in loop (led blinks), use the jogwheel to fine-adjust the Loop In point.6 RELOOP/EXITWhen in loop, exits the loop. When not in loop, enables the last triggered loop and jumps to its beginning.Same action.7 CUE CALL <When in loop, halves the size of the loop in beats. When not in loop, loads the previous saved loop slot or saves it if emptyDelete the current Saved loop slot.8 CUE CALL >When in loop, doubles the size of the loop in beats. When not in loop, loads the next saved loop slot or saves it if emptySaves a loop of the selected beats in size to an empty Saved loop slot.9 BEAT SYNCSyncs deck with the opposite one (matches BPM and phase) or with the Master-Deck (if more than 2 decks). Press for more than 2 seconds to set a Deck as Master-Deck.Selects the next available % range for Pitch10 PITCHAdjust the tempo/pitch of the deck..11 PADSOperation depends on selected Pads mode
See Pads in VirtualDJ manualOperation depends on selected Pads mode
See Pads in VirtualDJ manual12 PAD MODESSelect a mode for the Pads (Hotcues, Loops, Beat-Jump and Sampler)
See Pads in VirtualDJ manualSelect an alternative mode for the Pads (Cue-Loop, Pad FX, Loop Roll and Key-Cue)
See Pads in VirtualDJ manual13 CROSSFADERBlends audio between the Left and Right assigned decksAdditional function: If Fader Start is enabled, start deck when reach its side, and stop if reaches the other side. See Settings14 DECK LEVELAdjust the Output volume of the Left/Right assigned deck.Additional function: If Fader Start is enabled, start deck when fader is moving from the zero position to a higher one and stop the deck when fader reaches zero/minimum position. See Settings15 CUE/PFLSends left/right deck's audio (pre-fader) signal to Headphones channel, for pre-listening .16 FILTERApply a High-Low pass Filter to Left/Right assigned deck. When in middle position, no Filter is applied..17 EQUALIZERAdjust the Low, Mid and High frequencies of the Left/Right assigned deck.18 EQUALIZERAdjust the applied Gain. When in middle position, the applied gain is following the zeroDB VDJ setting value. 19 VU METERDepending on the selected mode ( see Settings ), the leds indicate the Master Stereo Output level or the level of the Left/Right assigned decks.. 20 LOADLoads the selected track from Browser to Left/Right assigned decksLeft LOAD : sets Sideview as focused Browser window.
Right LOAD : Cycles Sideview view (Automix, Sidelist, Sampler, Karaoke and Shortcuts)21 BROWSEScroll through files/folders. Push to toggle focus between Folders and Tracks Lists in BrowserPush to set focus to Folders List.. If focus is in Folders List, open/close sub-folders22 PHONES MIXBlends audio in Headphones, between the Decks that their PFL/CUE is enabled and the Master Output. 23 PHONES LEVELAdjust the Volume of the Headphones output. 24 MASTER LEVELAdjust the Volume of the Master output. 25 MASTER CUEWhen enabled, sends audio signal from the Master Output to Headphones channel (PHONES MIX knob needs to be at a position higher to minimum. 26 BEAT <>Select the previous/next size in beats for the selected Beat-aware Effect 27 FX SELECTSelect the next available Effect for the selected Deck or MasterSelect the previous available Effect for the selected Deck or Master 28 FX ASSIGNSelect the Deck (Left/Right) or Master to which the selected Effect will apply to 29 FX LEVELAdjust the 1st Parameterof the selected EffectAdjust the 2nd Parameter (if available) of the selected Effect30 FX ONTriggers the selected Effect to the selected Deck or MasterOpen/close the GUI of the selected Effect at the side of the Browser to get more details about the selected Effect Front & Rear