Kinggonch
right... first post and first time at doing the whole timecode thing so be gentel...
i have vista 64 ultimate on my laptop. fresh install.. with asio 4 all installed.
my mixer is a numark dxm10 with ma old gemini decks.
i have set the primary oudio and recording device to usb audio device and disabled the on board one.
now what im getting is... when i go to config to select dual timecodes, 3 line mixxer and asio driver. ok that, and it comes up.. 'error in the ASIO sound driver, not enough channels' and reverts back to default settings.
WTF
i know vista 64 is an arse but.... anyone have any ideas?
i have vista 64 ultimate on my laptop. fresh install.. with asio 4 all installed.
my mixer is a numark dxm10 with ma old gemini decks.
i have set the primary oudio and recording device to usb audio device and disabled the on board one.
now what im getting is... when i go to config to select dual timecodes, 3 line mixxer and asio driver. ok that, and it comes up.. 'error in the ASIO sound driver, not enough channels' and reverts back to default settings.
WTF
i know vista 64 is an arse but.... anyone have any ideas?
发表时间 Mon 01 Dec 08 @ 1:04 pm
dj t boogie
what soundcard u using?
发表时间 Tue 02 Dec 08 @ 1:11 am
Kinggonch
what soundcard u using?
the numark dxm01 has a built in usb sound card
the numark dxm01 has a built in usb sound card
发表时间 Tue 02 Dec 08 @ 11:42 am