快速登录:  

Forum: Old versions

话题: Timecoded Vinyl issues

由于该帖子已年深日久,可能包含陈旧过时或描述错误的信息。

i used my time coded vinyl recently and on one of my decks during playback the track randomly jumps from one part of the song to another. At first i thought my needles were fucked up but after replacing them i still had the same problem and it wasnt that my needles were jumping off the vinyl.......could someone please help me trouble shoot im using version 4.2
 

发表时间 Mon 23 Apr 07 @ 6:46 am
listen2PRO InfinityMember since 2005
what is your setup of pc sepec and hardware being used?
 

发表时间 Mon 23 Apr 07 @ 2:17 pm
Im using a DELL Pentium M processor 1.5 Ghz 598 Mhz and 512 of RAM....with an 200gig external hard drive and MAYA 44 USB sound card.....2 numark 1625 TT and numark mixer.
 

发表时间 Mon 23 Apr 07 @ 5:50 pm
listen2PRO InfinityMember since 2005
Well the ram is on the low side so that could be one issue, does the waves in the config windows look ok? and do they get 100%? Usually skips and jumps are reading problems either with the pc or with the tcv and maybe old needles. If your TCV are reading 100% constantly then i would look more at the pc for the fix since that would indicate the hardware(tcv) is functioning properly.
 

发表时间 Mon 23 Apr 07 @ 6:16 pm
Ok Thanks......The vinyl does read at 100% so im pretty sure they are ok. Its just a bit strange since the setup has been working fine for over a year. Anyhow im going to try and isolate the problem by checking one thing out at a time.
 

发表时间 Mon 23 Apr 07 @ 6:48 pm
listen2PRO InfinityMember since 2005
Also could be a conflict with something else you could have added to the system, possible IRQ conflict but it sounds at least there is no doubt that it's a pc side issue.
 

发表时间 Mon 23 Apr 07 @ 7:46 pm


(陈旧帖子或论坛版块会自动关闭)