on the bright side
DJ' ing for couple dancer. I play the full song , then i have about 1 or 2 Seconds of silence to give the dancer the chance to thank each other for the dance an decide wether they have another dance or not. So it would be great to have in the Options -Automix- Skiplenghts the possibility to put negativ values to create a silence between the songs. Actually you can fill in only positiv values for fading.
发表时间 Tue 28 Feb 23 @ 9:28 am
locoDog
setting fadeLength as a negative number
发表时间 Tue 28 Feb 23 @ 9:39 am
klausmogensen
locodog wrote :
setting fadeLength as a negative number
I've never thought of that :D
I knew about the 2 sec gap option in the dropdown, but had never checked how that registered in the settings, and if it could be changed it further
Good stuff!
发表时间 Tue 28 Feb 23 @ 10:31 am
brille1
Nice …
Though I would prefer a dedicated setting or a different control label if selection is "None (back to back)".
No-one can remember this peculiar feature a few months later.
Though I would prefer a dedicated setting or a different control label if selection is "None (back to back)".
No-one can remember this peculiar feature a few months later.
发表时间 Tue 06 Jun 23 @ 6:58 pm
brille1
Set
fadeLength = -2.0… Didn't work. Songs were played without pause, one after the other.
发表时间 Tue 13 Jun 23 @ 8:16 pm
brille1
OK, here's a hint to the solution: You must select one of the Fade Automix modes.
Only then, fadeLength is being considered. The GUI then adds a dedicated Fade Length sub menu to the Automix menu. And this sub menu even comes with a preset value of "-2", aka "2s gap":
Only then, fadeLength is being considered. The GUI then adds a dedicated Fade Length sub menu to the Automix menu. And this sub menu even comes with a preset value of "-2", aka "2s gap":
发表时间 Fri 23 Jun 23 @ 4:57 pm
klausmogensen
It does indeed work setting it in the settings:
发表时间 Fri 23 Jun 23 @ 7:17 pm