Hi all,
just thought I would share this with you.
I upgraded my laptop recently and found it to be WiDi enabled. (Asus N56VM)
More info here about WiDi:
http://youtu.be/D7mlNquHnCQ
So I purchased a Belkin WiDi receiver in a sale @ £49.
http://www.amazon.co.uk/Belkin-ScreenCast-F7D4501DE-Wireless-Display/dp/B0057XIYYO
I have a regular venue that has the AV distribution server down in the basement and the DJ Booth is upstairs and it is quite a way for a cable run and I have never been able to get a good picture back up into the main venu to display on the Video Monitors and the large Projector Screen.
I was a bit dubious at first because this venue has 3ft solid brick walls, but to my surprise I obtained a 4 bar signal readout in the WiDi software and now I can run full 1080p video from VDJ over WiDi into the venue's AV system.
It is very easy to stup and and just auto-connects once you have paired the receiver to your laptop.
There is a slight video/audio sync difference but I take this out with the new VDJ Delay setting in the video tab.
No more wires and no more poor quality signal.
I hope this helps someone in the same predicament.
ps: I also connect the WiDi receiver to my rear screen projector so I can place the screen anywhere in a room without long lengths of cables
pps: you can have more than one receiver that the Widi enabled laptop can connect to at one time.
just thought I would share this with you.
I upgraded my laptop recently and found it to be WiDi enabled. (Asus N56VM)
More info here about WiDi:
http://youtu.be/D7mlNquHnCQ
So I purchased a Belkin WiDi receiver in a sale @ £49.
http://www.amazon.co.uk/Belkin-ScreenCast-F7D4501DE-Wireless-Display/dp/B0057XIYYO
I have a regular venue that has the AV distribution server down in the basement and the DJ Booth is upstairs and it is quite a way for a cable run and I have never been able to get a good picture back up into the main venu to display on the Video Monitors and the large Projector Screen.
I was a bit dubious at first because this venue has 3ft solid brick walls, but to my surprise I obtained a 4 bar signal readout in the WiDi software and now I can run full 1080p video from VDJ over WiDi into the venue's AV system.
It is very easy to stup and and just auto-connects once you have paired the receiver to your laptop.
There is a slight video/audio sync difference but I take this out with the new VDJ Delay setting in the video tab.
No more wires and no more poor quality signal.
I hope this helps someone in the same predicament.
ps: I also connect the WiDi receiver to my rear screen projector so I can place the screen anywhere in a room without long lengths of cables
pps: you can have more than one receiver that the Widi enabled laptop can connect to at one time.
发表时间 Mon 25 Feb 13 @ 5:07 pm
Interesting and cool!! Thanks for sharing.
发表时间 Mon 25 Feb 13 @ 7:39 pm
beatbreaker1 wrote :
Interesting and cool!! Thanks for sharing.
Your very welcome - and thank you for your comment.
I hope other people find it useful as well.
发表时间 Tue 26 Feb 13 @ 5:00 am
what does the new delay feature delay? the audio or the video? I am having a isse with the video lagging the audio. Thanks
发表时间 Wed 05 Jun 13 @ 11:23 am
@ VIP DISCO & KARAOKE, very nice. I just purchased a new laptop for my son and it has WIDI. Made me wonder if this could work at venues.
May have to upgrade my lappy soon.
@ pricefarms1... is the delay due to long cable lengths between your DJ system and the monitors/video gear or is the lag experienced in a traditional setup?? The feature discussed is for correcting audio/video sync issues due to long cable lengths and/or elaborate video distribution systems.
May have to upgrade my lappy soon.
@ pricefarms1... is the delay due to long cable lengths between your DJ system and the monitors/video gear or is the lag experienced in a traditional setup?? The feature discussed is for correcting audio/video sync issues due to long cable lengths and/or elaborate video distribution systems.
发表时间 Wed 05 Jun 13 @ 2:52 pm
I'm trying to send wireless video to my TV and wireless audio to my sound setup, I'm using a My Wireless tv for the video, And a shure slx body pack for my audio. Is anybody else doing a wireless Video & Karaoke DJ Show? Thanks for any input.
发表时间 Fri 07 Jun 13 @ 8:27 am
Any way to get this working on Bootcamp? Since Apple uses Broadcom network cards, not Intel, I think this is a NO-GO...
发表时间 Thu 18 Jul 13 @ 4:13 am
i have system widi and must say .... nice
zero latency ... good system
zero latency ... good system
发表时间 Mon 19 Aug 13 @ 5:15 pm
My audio and video is out of sync. Any suggestions
发表时间 Mon 30 Sep 13 @ 4:44 pm
check your source...i mean...is it out of sync when you play it with an external media player...?
发表时间 Tue 01 Oct 13 @ 1:46 am
It works fine when I'm plugged directly with the HDMI cord. But when I extend my display to the Widi reciever the audio doesn't match up with the video. I try to adjust the latency in Virtual but that doesn't work. Any suggestions?
发表时间 Sun 20 Oct 13 @ 4:21 pm
VDJ does have a video delay slider you could try......
发表时间 Tue 22 Oct 13 @ 9:49 am
I have setting in widi config for SPEED (don t quality)
The latest firmware in WIDI (I have NETGEAR)
new drivers for widi in pc and graphics
The latest firmware in WIDI (I have NETGEAR)
new drivers for widi in pc and graphics
发表时间 Tue 22 Oct 13 @ 1:53 pm
widi in Win 8.1 little lugs
发表时间 Tue 12 Nov 13 @ 2:02 pm
Where can I find the video delay slider in VDJ? Is this VDJ 7 or VDJ 8
发表时间 Wed 10 Dec 14 @ 9:47 am
VDJ8: go to config, options, video, find videoDelay. By default it is set to 0.000000. experiment with values in that field and check the results. If a positive number in the field makes it worse you may want to put a negative value in the field, such as -1.000000.
VDJ7: go to config, select the video tab, at the bottom of the page is a field labelled Delay. Default value is 0. Again, experiment to find the best setting.
I've never had to adjust these settings in v7 or v8 so I am ignorant as to the best settings for your situation.
Good luck,
Tim
VDJ7: go to config, select the video tab, at the bottom of the page is a field labelled Delay. Default value is 0. Again, experiment to find the best setting.
I've never had to adjust these settings in v7 or v8 so I am ignorant as to the best settings for your situation.
Good luck,
Tim
发表时间 Wed 10 Dec 14 @ 10:56 am
Ok thanks I you that but I can't seem to sink the video with the audio using the widi adapter. This is frustrating because I know this should work correctly. Will updating the firmware of the widi adapter help.
发表时间 Wed 10 Dec 14 @ 3:02 pm
DeAlmaro wrote :
Ok thanks I you that but I can't seem to sink the video with the audio using the widi adapter. This is frustrating because I know this should work correctly. Will updating the firmware of the widi adapter help.
Just change the video delay in VDJ settings - a minus or plus figure is accepted - I just experimented until I found the best settings - you have to restart vdj after each change.
发表时间 Wed 24 Dec 14 @ 10:56 am
DeAlmaro wrote :
Ok thanks I you that but I can't seem to sink the video with the audio using the widi adapter. This is frustrating because I know this should work correctly. Will updating the firmware of the widi adapter help.
The Belkin Adapter auto senses a firmware update once you make an initial connection via widi.
发表时间 Wed 24 Dec 14 @ 10:57 am