bassline65
Goodday
I just bought a Denon DN-MC600 controllor to use on my IMAC my current setting are as discribe in the manual I recived with the DN-MC600 hardware, but when conected same to my IMAC computer, the only funtion thats work is the mixer section, light meter and volumes contros is ingage but the decks, Sound selection, deck load ect on the hardware is none funtiona in the V-Dj software, is there something I need to instal on my Imac to enable the hardware to control the J-Dj software?
Kindly advise
Thanks
发表时间 Mon 19 Nov 12 @ 1:58 pm
Moderation staff
Please do not open more than one topic on the same subject.
You have already asked this same question in the following topic where you can find answers: http://www.virtualdj.com/forums/171180/x/
As already advised, you need to make sure that the MC6000 is operating on the correct MIDI channels and is also configured as described on the MC6000 config & troubleshooting page: http://www.virtualdj.com/wiki/DN-MC6000.html
Also, as previously advised, make sure that you have the latest VirtualDJ LE for MC6000 installed and the latest firmware installed on the MC6000.
[Duplicate topic closed]
You have already asked this same question in the following topic where you can find answers: http://www.virtualdj.com/forums/171180/x/
As already advised, you need to make sure that the MC6000 is operating on the correct MIDI channels and is also configured as described on the MC6000 config & troubleshooting page: http://www.virtualdj.com/wiki/DN-MC6000.html
Also, as previously advised, make sure that you have the latest VirtualDJ LE for MC6000 installed and the latest firmware installed on the MC6000.
[Duplicate topic closed]
发表时间 Tue 20 Nov 12 @ 5:15 am