快速登录:  

Forum: General Discussion

话题: Timecode CD's

由于该帖子已年深日久,可能包含陈旧过时或描述错误的信息。

I have been using VDJ for about two weeks with no problems and it sounds great. My timecode quality says 0% and plays fine, do I need to get it to say 100%..???

what mode should I be using? Also what is the difference between the modes?

1. absolute
2. smart
3. relative

**MODERATOR** - Your second Thread has been deleted and joined to this one as the subject was the same.
 

发表时间 Thu 04 May 06 @ 4:56 pm
Make sure your sound in is muted on your sound card (one), and yes, it would be good that it shows 100% cuz if not then u will have problems of it not responding correctly (two).

BTW, what sound card are u using?
 

发表时间 Thu 04 May 06 @ 10:17 pm
maya 44 soundcard
 

发表时间 Thu 04 May 06 @ 11:52 pm
LOWER the volume at the inputs.. 100 % is only needed for scratch
 

发表时间 Fri 05 May 06 @ 12:23 am
Probably the input of the TCCD is too loud. Lower the volume in the maya config. To open this config: VDJ->Config->Sound card setup->lowlatency timecode vinyls->Config timecode->Asio config
Ewout
 

发表时间 Fri 05 May 06 @ 12:27 am


(陈旧帖子或论坛版块会自动关闭)