jpboggis
It's possible to set/hide all of the symbols on the DAC-3 display except for the SINGLE indicator. I'd like to use this as a status indicator, but it's not present in DAC3Mapper.h - Is there any reason why this isn't present?
Also, it would be neat if it was possible to address the individual segments of digits.
Also, it would be neat if it was possible to address the individual segments of digits.
发表时间 Thu 24 Nov 05 @ 1:02 pm
Dj Xeo
the values passed to the DAC3 by the compiled dll will be asci (or similar) values not pixel information
发表时间 Fri 25 Nov 05 @ 5:41 am
lopez453
each digit has 7 segments, maybe it's one bit per segment
发表时间 Fri 25 Nov 05 @ 12:07 pm
jpboggis
The SetDigit() function takes a numeric parameter for the value to set the digit to. This can be 0-9 (To display 0-9), 0x0A (DIsplays '-') or 0x0B (Turns off digit.)
Assuming the DAC-3 SDK itself (From Visiosonic) allows individual segments to be addressed, perhaps support for 0x(NN)0 could be added to the SetDigit() function (Where NN is a value derived from the bit mask of segments to display.)
Assuming the DAC-3 SDK itself (From Visiosonic) allows individual segments to be addressed, perhaps support for 0x(NN)0 could be added to the SetDigit() function (Where NN is a value derived from the bit mask of segments to display.)
发表时间 Fri 25 Nov 05 @ 2:34 pm