TheOuterside
So I was messing with "options". Ended up resetting defaults. Before, I had the knobs on controller as a default set. Eg: turn on controller, load VDJ8 and whatever the control eq's were set at the skin show the same postions.
I can't remember what option it was to allow that. Any Idea???
I can't remember what option it was to allow that. Any Idea???
发表时间 Wed 12 May 21 @ 9:06 pm
locoDog
search
takeovermode
you want instant
possible turn
resetEQ
to off as well
takeovermode
you want instant
possible turn
resetEQ
to off as well
发表时间 Wed 12 May 21 @ 9:14 pm
TheOuterside
The instant option works. but only when I touch the knobs on controller. I guess I can work with that. I just had some setting where I would run VDJ and the eqs would automatically set whatever the controller was set at.
发表时间 Wed 12 May 21 @ 9:25 pm
locoDog
what controller?
发表时间 Wed 12 May 21 @ 9:26 pm
TheOuterside
NS7 III
发表时间 Wed 12 May 21 @ 9:30 pm
locoDog
can't think of how a setting would make a difference, booting the program and it calling refresh_controller "should" sync the skin to the controller.
I'm not doubting you, you have the device right there. I'm just working from what I've picked up over the years, this might be a dev question.
I'm not doubting you, you have the device right there. I'm just working from what I've picked up over the years, this might be a dev question.
发表时间 Wed 12 May 21 @ 11:03 pm
TheOuterside
TY locodog, I'll use your idea until I stumble across whatever I did before.
发表时间 Thu 13 May 21 @ 5:49 pm